The kitchen faucet always needs to be replaced, and the most troublesome part is the angle valve. If the angle valve is not installed properly, there will always be water leaking drop by drop. If you want to install the angle valve, you need to talk about simple skills

First, close the main water valve. Clean up the interface of the angle valve to be installed. After replacing the original angle valve, carefully clean up the scale and empty the remaining water in the pipe.

Choose the right angle valve. Close the valve on the angle valve, and recognize where the two ports of the angle valve are to be connected.

Use raw tape to wrap the wire of the angle valve tightly, layer by layer, from the inside to the outside. Note that usually more than 5 layers are required, not afraid of thick

Schematic diagram of wrapped angle valve

Rotate the angle valve along the link direction of the wire port and tighten it into the wire port of the wall. Be careful not to use force when screwing in. You can first tighten with your hands. After tightening, you can use a wrench or other tools to twist the angle valve by half a turn, and try to adjust the position of the water outlet to a position that is convenient for connecting the water pipe.