The Sink Mixer Cartridge may be the most difficult part of your sink faucet to change. It's usually located on the bottom of the mixer, so you should start by unscrewing the grub screw and unscrewing the handle of the sink mixer. It should be lifted straight out and you should have no problem doing so. Once the old cartridge has been removed, you can install the new one. Make sure to take the old cartridge with you when you shop.

There are two types of cartridges. Ceramic Disc Cartridges and ceramic disk cartridges. You must ensure the right type for your sink. You can also check the size of the nut. A replacement Mk2 Sink Mixer Cartridge is slightly smaller than the original one. Both types have the same size and height, so they're a direct replacement. To change your sink mixer cartridge, simply uninstall the old one and replace it with a new one.

The Mk2 is slightly different. The nut is smaller than the Mk1 cartridge. A replacement Mk2 cartridge is the same height as the original, so you can remove it and replace it with the same type. The replacement Mk3 cartridge is slightly larger than the Mk2 cartridge, but the same height. To replace the old one, you need to clean the inside of the chamber and reinstall the nut.

There are two types of Sink Mixer Cartridges. One type has a spout that features the C spout. The other type has a rinse and C spout. You may also notice that water drips out of the spout and around the body of the tap. The seals and valves of the tap may have failed and need to be replaced. A replacement is an ideal solution if your sink mixer has begun to leak.

A replacement cartridge for an Mk1 sink mixer is the same size as the Mk2 cartridge, but it's easier to replace a Mk2 one than a MK2 sink mixer. Both types of replacement cartridges are similar, and both are a good choice if you're replacing the cartridges for your MK3 faucet. If you're using an MK1 cartridge, you should make sure it fits properly in order to prevent water leaks.

To replace the cartridge in a Mk2 sink mixer, you must first remove the old one. Then, you should clean the inside of the chamber of the sink mixer. You should also replace the nut if you're replacing an Mk1 sink mixer. If the nut is damaged, you should replace the entire cartridge. If the nut is damaged, you can use a replacement Mk2 nut instead.